Spektrum 1S 50C LiPo Battery. This is an optional battery for micro helicopters, drones, or planes that require a 210mAh battery with a JST PH1.25 connector and an exceptional 50C punch! Package includes one battery.

Features:

• Powerful 50C discharge
• 210mAh in a Small and lightweight package
• Versatile for a variety of airborne applications

Specifications:

• Nominal Voltage: 3.7C (1S)
• Capacity: 210mAh
• Maximum Charge Rate: 1C (0.2A)
• Peak Discharge Rate: 50C
• Cell Configuration: 1S1P
• Watt Hours: 0.79Wh
• ROAR Approved: No
• Battery Connector: PH 1.25 (Ultra Micro)
• Dimensions (LxWxH): 1.88x0.39x0.22in (48x10x5.7mm)
• Weight: 0.19oz (5.6g)

Includes:

• (1) 1S LiPo Battery 50C w/JST Connector

Important Litium Polymer Safety Information:

• DO NOT leave a battery in your model when charging
• DO NOT leave lithium batteries unattended when charging
• ALWAYS balance charge lithium battery
• ALWAYS use a LiPo Safe charging bag/box
• YOU MUST use a Li-Poly specific charger to charge lithium batteries (NiMH or NiCD only chargers WILL NOT WORK!)
• YOU MUST not over discharge lithium battery packs
• READ & UNDERSTAND the instructions carefully before operating this battery

NOTE:When using high energy Li-Polymer Batteries, please do not over-discharge or over-charge batteries as this will result in overheated batteries. Discharging capacity can't exceed 80% of the max capacity of the pack after full charging to ensure a good cycle performance. It is recommended to fully charge a brand new battery before using and only discharge the battery 50% for the first 5 cycles. Always monitor race time and/or set a low voltage warning on ESC (End voltage cannot be lower than 3.2v per cell). Do not use a battery that has too low a voltage. Do not expose batteries to sunshine or store/charge batteries at temperatures above 35°C or in a closed car. The high-temperature environment could cause damage to the pack or make it burst. If the battery becomes hot while fast charging, high current discharging, or racing, do not charge it until it has cooled completely. Wait about 20 mins, then inspect prior to recharging.